#4 EYELASH CLEANSER - COMPOSITION FOR LASH LAMINATION
This product is design to cleanse the lash prior to lash lamination/lash lifting / lash perming.
This product is untlra-concentrated and only needs to be used sparely after a Micellar/Water-based makeup remover and before a Lash Primer.
The Eyelash Cleanser is an extra step to make sure the lashes are free from any extra oils, makeup residue to allow the lift solutions to work their magic.
INSTRUCTIONS FOR USE:1. Cleanse the eyebrow area with an oil-free makeup remover. Degrease the eyebrows using #4 Eyelash Cleanser. Use of scrbs and peel is forbidden.
2. Comb the eyebrows with a disposable eyebrow brush. Then apply a thin layer of Brow Perm Fixer on dry eyebrow hairs to fix them. Slowly and gently create the desired shape with the eyebrow brush, considering the natural direction of the hair growth.
3. Apply Zone Gel or Eyebrow Paste on the skin around the eyebrows, avoiding contact with hairs.
4. Apply a thin layer of Composition #1 Brow Lift on hairs. The exposure time is 6-15 minutes, depending on the quality and density of the hairs.
- 6 - 8 minutes for thin hairs
- 8 - 10 minutes for normal dyed hairs
- 10 - 12 minutes for dense, thick, undyed hairs. In case of coarse hairs, exposure time can be increased up to 15 minutes.
Right after applying the composition, it is recommended to cover the eyebrows with film, without any pressing.
5. As the exposure time of the Composition #1 is over, completely remove it with a dry cotton swab in the direction of hair growth. Gently correct the eyebrow shape if needed.
6. Apply Composition #2 Brow Sculpt. The exposure time is the same as for Composition #1 Brow Lift.
7. As the exposure time of Composition #2 Brow Sculpt passed, remove it with a dry cotton swab.
8. Gently remove Brow Perm Fixer and composition residues, using Saline Solution.
9. Carry out the tinting procedure, using the professional eyelash and eyebrow dye Bronsun. Thoroughly mix a small amount of eyelash and eyebrow dye Bronsun with Milk-Cream developer Bronsun in a 1:1 ratio in a non-metallic tare. The exposure time is 2-5 minutes, depending on the chosen shade and the desired effect.
10. As the exposure time of the dye is over, remove it with a dry cotton pad. Thoroughly wash off the dye residues with Saline Solution.
11. In case of necessity, apply Protein Reconstruction Composition Proetin Botex over the entire eyebrow area. The exposure is 10-15 minutes. The composition should be heated in hot water for 2-2.5 minutes prior to use.
12. Apply Composition #3 Brow Essence on the eyebrows with a microbrush, creating the desired shape.
Do not wash the composition off.